Launched in 2004, dmesgd aims to provide a user-submitted repository of searchable *BSD dmesgs. The dmesg(8) command displays the system message buffer's content, and during boot a copy is saved to /var/run/dmesg.boot. This buffer contains the operating system release, name and version, a list of devices identified, plus a whole host of other useful information. We hope others find this resource useful and further contribute to its growth. Contact us at [ admin at lists dot nycbug dot org ].


Date: 2019-10-12 15:32:42
From: Sevan / Venture37
Description: 867Mhz PowerBook G4 Titanium (PowerBook3,5, Aiport installed)
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017,
2018, 2019 The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California.  All rights reserved.

NetBSD 9.99.16 (GENERIC) #0: Sat Oct 12 13:27:43 BST 2019
	xxx@xxx:/usr/obj/macppc/sys/arch/macppc/compile/GENERIC
total memory = 1024 MB
oea_startup: failed to allocate DEAD ZONE: error=12
avail memory = 979 MB
timecounter: Timecounters tick every 10.000 msec
Kernelized RAIDframe activated
found openpic PIC at 80040000
OpenPIC Version 1.2: Supports 4 CPUs and 64 interrupt sources.
bootpath: /pci@f2000000/mac-io@17/ata-4@1f000/disk@0:0/netbsd
mainbus0 (root)
cpu0 at mainbus0: 7455 (Revision 3.3), ID 0 (primary)
cpu0: HID0 0x84d0c1bc<EMCP,TBEN,HIGH_BAT_EN,NAP,DPM,ICE,DCE,XBSEN,SGE,BTIC,LRSTK,FOLD,BHT>, powersave: 1
cpu0: 666.67 MHz, 256KB L2 cache no parity, 1MB no-parity L3 cache (DDR SRAM) at 5:1 ratio
memory0 at mainbus0: len=256
spdmem0 at memory0
spdmem0: SDRAM, no parity or ECC, 512MB, 133MHz (PC-133)
spdmem0: 13 rows, 10 cols, 2 banks, 4 banks/chip, 7.5ns cycle time
spdmem0: tAA-tRCD-tRP-tRAS: 3-20-20-45
spdmem0: voltage LvTTL (not 5V tolerant), refresh time 7.8us (self-refreshing)
spdmem1 at memory0
spdmem1: SDRAM, no parity or ECC, 512MB, 133MHz (PC-133)
spdmem1: 13 rows, 10 cols, 2 banks, 4 banks/chip, 7.5ns cycle time
spdmem1: tAA-tRCD-tRP-tRAS: 3-20-20-45
spdmem1: voltage LvTTL (not 5V tolerant), refresh time 7.8us (self-refreshing)
uni_n0 at mainbus0 address 0xf8000000
ki2c0 at uni_n0 address 0xf8001000
iic0 at ki2c0: I2C bus
fan at iic0 addr 0xc4 not configured
cereal at iic0 addr 0xe0 not configured
uninorth0 at mainbus0
pci0 at uninorth0 bus 0
pci0: i/o space, memory space enabled
pchb0 at pci0 dev 11 function 0
pchb0: Apple Computer UniNorth AGP Interface (rev. 0x00)
radeonfb0 at pci0 dev 16 function 0: ATI Technologies Radeon Mobility 9000 (M9) Lf (rev. 0x01)
trying to read disabled BIOS...
radeonfb0: No video BIOS, using default clocks
radeonfb0: refclk = 27.000 MHz, refdiv = 12 minpll = 125000, maxpll = 400000
radeonfb0: 64 MB aperture at 0xb8000000, 64 KB registers at 0xb0000000
radeonfb0: display 0: initial virtual resolution 1280x854 at 8 bpp
radeonfb0: using 32 MB per display
radeonfb0: port 0: physical 1280x854 60Hz
radeonfb0: port 1: physical 1280x854 60Hz
wsdisplay0 at radeonfb0 kbdmux 1: console (fb, vt100 emulation)
wsmux1: connecting to wsdisplay0
drm at radeonfb0 not configured
uninorth1 at mainbus0
pci1 at uninorth1 bus 0
pci1: i/o space, memory space enabled
pchb1 at pci1 dev 11 function 0
pchb1: Apple Computer UniNorth Host-PCI Bridge (rev. 0x00)
obio0 at pci1 dev 23 function 0: addr 0x80000000
obio0: enabling KeyLargo internal modem
zsc0 at obio0 irq 22,23
zstty0 at zsc0 channel 0
zstty1 at zsc0 channel 1
snapper0 at obio0 offset 0x10000: irq 30,1,2
pmu0 at obio0 offset 0x16000 irq 47:  rev. 12
pmu0: initializing IIC bus
iic1 at pmu0: I2C bus
pmu0: initializing RTC
pmu0: initializing ADB
nadb0 at pmu0: Apple Desktop Bus
pmu0: power-mgt not configured
smartbat0 at pmu0 addr 0: smart battery
flags: 4 present
ki2c1 at obio0
iic2 at ki2c1: I2C bus
cereal at iic2 addr 0xe0 not configured
deq0 at iic2 addr 0x35 Audio Codec (tas3004)
wdc0 at obio0 offset 0x1f000 irq 19, level triggered: DMA transfer
atabus0 at wdc0 channel 0
wdc1 at obio0 offset 0x20000 irq 20, level triggered: DMA transfer
atabus1 at wdc1 channel 0
wi0 at obio0 offset 0x30000 irq 57: 802.11 address 00:30:65:
wi0: using Lucent Embedded WaveLAN/IEEE
wi0: Lucent Firmware: Station (8.70.1)
snapper0: codec: TAS3004
audio0 at snapper0: playback, capture, full duplex
audio0: slinear_be:16 -> slinear_be:16 2ch 48000Hz, blk 64ms for playback
audio0: slinear_be:16 <- slinear_be:16 2ch 48000Hz, blk 64ms for recording
spkr0 at audio0: PC Speaker (synthesized)
wsbell at spkr0 not configured
ohci0 at pci1 dev 24 function 0: Apple Computer KeyLargo USB Controller (rev. 0x00)
ohci0: interrupting at irq 27
ohci0: OHCI version 1.0
usb0 at ohci0: USB revision 1.0
ohci1 at pci1 dev 25 function 0: Apple Computer KeyLargo USB Controller (rev. 0x00)
ohci1: interrupting at irq 28
ohci1: OHCI version 1.0
usb1 at ohci1: USB revision 1.0
cbb0 at pci1 dev 26 function 0: Texas Instruments PCI1410 PCI-CardBus Bridge (rev. 0x02)
cbb0: cacheline 0x8 lattimer 0x10
cbb0: bhlc 0x21008
cbb0: interrupting at irq 58
cardslot0 at cbb0
cardbus0 at cardslot0: bus 1
pcmcia0 at cardslot0
uninorth2 at mainbus0
pci2 at uninorth2 bus 0
pci2: i/o space, memory space enabled
pchb2 at pci2 dev 11 function 0
pchb2: Apple Computer UniNorth Host-PCI Bridge (rev. 0x00)
fwohci0 at pci2 dev 14 function 0: Lucent Technologies FW322/323 IEEE 1394 Host Controller (rev. 0x00)
fwohci0: interrupting at irq 40
fwohci0: OHCI version 1.0 (ROM=0)
fwohci0: No. of Isochronous channels is 8.
fwohci0: EUI64 00:0a:95:ff:fe:
fwohci0: Phy 1394a available S400, 1 ports.
fwohci0: Link S400, max_rec 2048 bytes.
ieee1394if0 at fwohci0: IEEE1394 bus
fwip0 at ieee1394if0: IP over IEEE1394
fwohci0: Initiate bus reset
fwohci0: Clear PME# now
gem0 at pci2 dev 15 function 0: Apple Computer GMAC Ethernet (rev. 0x01)
gem0: interrupting at irq 41
brgphy0 at gem0 phy 0: BCM5421 1000BASE-T media interface, rev. 1
brgphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto
gem0: Ethernet address 00:0a:95:, 10KB RX fifo, 4KB TX fifo
vmmask 67be0000 schedmask 7ffe0000 highmask 7ffe0000
timecounter: Timecounter "clockinterrupt" frequency 100 Hz quality 0
timecounter: Timecounter "mftb" frequency 33331610 Hz quality 100
fwohci0: BUS reset
fwohci0: node_id=0xc800ffc0, gen=2, CYCLEMASTER mode
ieee1394if0: 1 nodes, maxhop <= 0 cable IRM irm(0) (me)
ieee1394if0: bus manager 0
uhub0 at usb0: NetBSD (0000) OHCI root hub (0000), class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhub1 at usb1: NetBSD (0000) OHCI root hub (0000), class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
IPsec: Initialized Security Association Processing.
adbkbd0 at nadb0 addr 2: iBook keyboard
wskbd0 at adbkbd0 mux 1
wskbd0: connecting to wsdisplay0
wsmouse0 at adbkbd0 mux 0
adbms0 at nadb0 addr 3: EMP trackpad <tpad> 2-button, 400 dpi
wsmouse1 at adbms0 mux 0
adbbt0 at nadb0 addr 7: button device
AC Power: AC adapter offline.
wd0 at atabus0 drive 0
wd0: <ST98823A>
wd0: drive supports 16-sector PIO transfers, LBA48 addressing
wd0: 76319 MB, 155061 cyl, 16 head, 63 sec, 512 bytes/sect x 156301488 sectors
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 5 (Ultra/100)
wd0(wdc0:0:0): using PIO mode 4, DMA mode 2, Ultra-DMA mode 4 (Ultra/66) (using DMA)
atapibus0 at atabus1: 2 targets
cd0 at atapibus0 drive 0: <MATSHITACD-RW  CW-8121, , AA21> cdrom removable
cd0: drive supports PIO mode 4, DMA mode 2
cd0(wdc1:0:0): using PIO mode 4, DMA mode 2 (using DMA)
swwdog0: software watchdog initialized
boot device: wd0
root on wd0a dumps on wd0b
root file system type: ffs
kern.module.path=/stand/macppc/9.99.16/modules