Launched in 2004, dmesgd aims to provide a user-submitted repository of searchable *BSD dmesgs. The dmesg(8) command displays the system message buffer's content, and during boot a copy is saved to /var/run/dmesg.boot. This buffer contains the operating system release, name and version, a list of devices identified, plus a whole host of other useful information. We hope others find this resource useful and further contribute to its growth. Contact us at [ admin at lists dot nycbug dot org ]. Note that this site is not a substitute for sending the dmesg directly to the respective project.
Date: 2022-03-25 23:57:29
From: yamori813
Description: NTPD-GPS
---<<BOOT>>--- KDB: debugger backends: ddb KDB: current backend: ddb Copyright (c) 1992-2021 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD is a registered trademark of The FreeBSD Foundation. FreeBSD 12.3-STABLE yamori813_modify-n234744-445f3b685bf6 Fon_FON2305E_FDT mips gcc version 4.2.1 20070831 patched [FreeBSD] Preloaded elf kernel "kernel" at 0x80367c80. CPU: MIPS Technologies (RT3350 ) processor v76.150 MMU: Standard TLB, 32 entries (4K 16K 64K 256K 1M 16M 64M 256M pg sizes) L1 i-cache: 4 ways of 256 sets, 32 bytes per line L1 d-cache: 4 ways of 128 sets, 32 bytes per line L2 cache: disabled Config1=0xbea3319e<PerfCount,WatchRegs,MIPS16,EJTAG> Config2=0x80000000 Config3=0x420<DSPP,VInt> Config7=0x0 real memory = 33554432 (32768K bytes) Physical memory chunk(s): 0x00400000 - 0x01f7efff, 28831744 bytes (7039 pages) avail memory = 28217344 (26MB) random: no preloaded entropy cache arc4random: WARNING: initial seeding bypassed the cryptographic random device because it was not yet seeded and the knob 'bypass_before_seeding' was enabled. hostuuid: using 00000000-0000-0000-0000-000000000000 ULE: setup cpu 0 random: entropy device external interface WARNING: Device "g_ctl" is Giant locked and may be deleted before FreeBSD 14.0. null: <full device, null device, zero device> openfirm: <Open Firmware control device> WARNING: Device "openfirm" is Giant locked and may be deleted before FreeBSD 14.0. mem: <memory> nexus0: <MIPS32 root nexus> ofwbus0: <Open Firmware Device Tree> on nexus0 palmbus0: <MTK Palmbus> mem 0x10000000-0x101fffff on ofwbus0 cpupic0: <MIPS32 Interrupt Controller> on ofwbus0 sysc0: <MTK System Controller> mem 0-0xff on palmbus0 pinctrl0: <MTK Pin Controller> on ofwbus0 pinctrl0: GPIO mode start: 0x0000029d Processing 1 pin-config node(s) in pinctrl-0 for spi@b00 Processing 1 pin-config node(s) in pinctrl-0 for uartlite@c00 Processing 1 pin-config node(s) in pinctrl-0 for pinctrl pinctrl0: GPIO mode end : 0x000002d5 rstctrl0: <MTK Reset Controller> on ofwbus0 clkctrl0: <MTK Clock Controller> on ofwbus0 intc0: <MTK Interrupt Controller (v2)> mem 0x200-0x2ff irq 6 on palmbus0 gpio0: <MTK GPIO Controller (v1)> mem 0x600-0x633 irq 9 on palmbus0 gpiobus0: <OFW GPIO bus> on gpio0 cpulist0: <Open Firmware CPU Group> on ofwbus0 palmbus0: <timer@100> mem 0x100-0x11f irq 4 compat ralink,rt3050-timer (no driver attached) palmbus0: <watchdog@120> mem 0x120-0x12f irq 5 compat ralink,rt3050-wdt (no driver attached) palmbus0: <memc@300> mem 0x300-0x3ff irq 7 compat ralink,rt3050-memc (no driver attached) uart0: <MTK UART Controller> mem 0x500-0x5ff irq 8 on palmbus0 uart0: fast interrupt uart0: PPS capture mode: DCD gpioc0: <GPIO controller> on gpio0 palmbus0: <gpio@638> mem 0x638-0x65b disabled compat ralink,rt3050-gpio (no driver attached) palmbus0: <gpio@660> mem 0x660-0x683 disabled compat ralink,rt3050-gpio (no driver attached) spi0: <MTK SPI Controller (v1)> mem 0xb00-0xbff on palmbus0 spibus0: <OFW SPI bus> on spi0 mx25l0: <M25Pxx Flash Family> at cs 0 mode 0 on spibus0 mx25l0: device type mx25ll64, size 8192K in 128 sectors of 64K, erase size 64K uart1: <MTK UART Controller> mem 0xc00-0xcff irq 10 on palmbus0 uart1: console (57971,n,8,1) uart1: fast interrupt uart1: PPS capture mode: DCD ofwbus0: <usbphy> compat ralink,rt3050-usbphy (no driver attached) rt0: <Ralink RT3050 onChip Ethernet driver> mem 0x10100000-0x1010ffff irq 0 on ofwbus0 rt0: RT305XF Ethernet MAC (rev 0x00000000) rt0: use hardcoded [_MAC_XXXXXXXXXX] macaddr rt0: bpf attached rt0: Ethernet address: [_MAC_XXXXXXXXXX] mtkswitch0: <MTK Switch Driver> mem 0x10110000-0x10117fff irq 1 on ofwbus0 miibus0: <MII bus> on mtkswitch0 ukphy0: <Generic IEEE 802.3u media interface> PHY 0 on miibus0 ukphy0: OUI 0x000c43, model 0x0001, rev. 7 ukphy0: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto miibus1: <MII bus> on mtkswitch0 ukphy1: <Generic IEEE 802.3u media interface> PHY 1 on miibus1 ukphy1: OUI 0x000c43, model 0x0001, rev. 7 ukphy1: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto miibus2: <MII bus> on mtkswitch0 ukphy2: <Generic IEEE 802.3u media interface> PHY 2 on miibus2 ukphy2: OUI 0x000c43, model 0x0001, rev. 7 ukphy2: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto miibus3: <MII bus> on mtkswitch0 ukphy3: <Generic IEEE 802.3u media interface> PHY 3 on miibus3 ukphy3: OUI 0x000c43, model 0x0001, rev. 7 ukphy3: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto miibus4: <MII bus> on mtkswitch0 ukphy4: <Generic IEEE 802.3u media interface> PHY 4 on miibus4 ukphy4: OUI 0x000c43, model 0x0001, rev. 7 ukphy4: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto etherswitch0: <Switch controller> on mtkswitch0 mdio0: <MDIO> on mtkswitch0 ofwbus0: <wmac@10180000> mem 0x10180000-0x101bffff irq 2 compat ralink,rt3050-wmac (no driver attached) ofwbus0: <otg@101c0000> mem 0x101c0000-0x101fffff irq 3 compat ralink,rt3050-otg (no driver attached) gpioled0: <GPIO LEDs> on ofwbus0 gpiopps0: <GPIO PPS> on ofwbus0 gpiopps0: PPS input on gpio0 pin 12 clock0: <Generic MIPS32 ticker> on nexus0 Timecounter "MIPS32" frequency 160000000 Hz quality 800 Event timer "MIPS32" frequency 160000000 Hz quality 800 Device configuration finished. Timecounters tick every 10.000 msec vlan: initialized, using hash tables with chaining lo0: bpf attached tcp_init: net.inet.tcp.tcbhashsize auto tuned to 512 mtkswitch0port0: link state changed to DOWN mtkswitch0port1: link state changed to DOWN mtkswitch0port2: link state changed to DOWN mtkswitch0port3: link state changed to DOWN mtkswitch0port4: link state changed to DOWN GEOM: new disk flash/spi0 Trying to mount root from cd9660:/dev/flash/spi0s.rootfs.uzip []... flash/spi0: slice 00000000-0000ffff: u-boot (63KB) flash/spi0: slice 00010000-0001ffff: u-boot-env (63KB) flash/spi0: slice 00020000-0011ffff: kernel (1023KB) flash/spi0: slice 00120000-007fffff: rootfs (7039KB) flash/spi0: slice 00020000-007fffff: upgrade (8063KB) cd9660: RockRidge Extension Warning: no time-of-day clock registered, system time will not be set accurately Dual Console: Serial Primary, Video Secondary start_init: trying /sbin/init mtkswitch0port0: link state changed to UP random: unblocking device. lo0: link state changed to UP /tmp: optimization changed from SPACE to TIME