Launched in 2004, dmesgd aims to provide a user-submitted repository of searchable *BSD dmesgs. The dmesg(8) command displays the system message buffer's content, and during boot a copy is saved to /var/run/dmesg.boot. This buffer contains the operating system release, name and version, a list of devices identified, plus a whole host of other useful information. We hope others find this resource useful and further contribute to its growth. Contact us at [ admin at lists dot nycbug dot org ]. Note that this site is not a substitute for sending the dmesg directly to the respective project.
Date: 2022-10-23 23:41:19
From: yamori813
Description: IOData_WN-G300R
---<<BOOT>>--- ar934x_chip_init_gmac: gmac_cfg=0x00000140 ar934x_configure_gmac: ETH_CFG=0x00003000 KDB: debugger backends: ddb KDB: current backend: ddb Copyright (c) 1992-2021 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD is a registered trademark of The FreeBSD Foundation. FreeBSD 12.4-STABLE zrouter_yamori813-n234777-85459b313e5c IOData_WN-G300R mips gcc version 4.2.1 20070831 patched [FreeBSD] Preloaded elf kernel "kernel" at 0x80377540. CPU: MIPS Technologies (Atheros AR9341 rev 1) processor v76.151 MMU: Standard TLB, 32 entries (4K 16K 64K 256K 1M 16M 64M 256M pg sizes) L1 i-cache: 4 ways of 512 sets, 32 bytes per line L1 d-cache: 4 ways of 256 sets, 32 bytes per line L2 cache: disabled Config1=0xbee3519e<PerfCount,WatchRegs,MIPS16,EJTAG> Config2=0x80001000 Config3=0x2c20<ULRI,DSP2P,DSPP,VInt> Config7=0x80000800<WII> real memory = 33554432 (32768K bytes) Physical memory chunk(s): 0x0040a000 - 0x01f7efff, 28790784 bytes (7029 pages) avail memory = 27951104 (26MB) random: no preloaded entropy cache arc4random: WARNING: initial seeding bypassed the cryptographic random device because it was not yet seeded and the knob 'bypass_before_seeding' was enabled. hostuuid: using 00000000-0000-0000-0000-000000000000 random: entropy device external interface snd_unit_init() u=0x00ff8000 [512] d=0x00007c00 [32] c=0x000003ff [1024] feeder_register: snd_unit=-1 snd_maxautovchans=16 latency=2 feeder_rate_min=1 feeder_rate_max=2016000 feeder_rate_round=25 WARNING: Device "g_ctl" is Giant locked and may be deleted before FreeBSD 14.0. mem: <memory> null: <full device, null device, zero device> nexus0: <MIPS32 root nexus> argemdio0: <Atheros AR71xx built-in ethernet interface, MDIO controller> at mem 0x19000000-0x19000fff on nexus0 mdio0: <MDIO> on argemdio0 mdioproxy0: <MII/MDIO proxy, MDIO side> on mdio0 clock0: <Generic MIPS32 ticker> on nexus0 Timecounter "MIPS32" frequency 267500000 Hz quality 800 Event timer "MIPS32" frequency 267500000 Hz quality 800 argemdio1: <Atheros AR71xx built-in ethernet interface, MDIO controller> at mem 0x1a000000-0x1a000fff on nexus0 mdio1: <MDIO> on argemdio1 mdioproxy1: <MII/MDIO proxy, MDIO side> on mdio1 arswitch0: <Atheros AR9340 Ethernet Switch (ver 0 rev 0)> on mdio1 arswitch0: ar9340_hw_global_setup: GMII arswitch0: ar9340_hw_global_setup: PHY4 - CPU miibus0: <MII bus> on arswitch0 ukphy0: <Generic IEEE 802.3u media interface> PHY 0 on miibus0 ukphy0: OUI 0x00c82e, model 0x0004, rev. 2 ukphy0: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto miibus1: <MII bus> on arswitch0 ukphy1: <Generic IEEE 802.3u media interface> PHY 1 on miibus1 ukphy1: OUI 0x00c82e, model 0x0004, rev. 2 ukphy1: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto miibus2: <MII bus> on arswitch0 ukphy2: <Generic IEEE 802.3u media interface> PHY 2 on miibus2 ukphy2: OUI 0x00c82e, model 0x0004, rev. 2 ukphy2: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto miibus3: <MII bus> on arswitch0 ukphy3: <Generic IEEE 802.3u media interface> PHY 3 on miibus3 ukphy3: OUI 0x00c82e, model 0x0004, rev. 2 ukphy3: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto etherswitch0: <Switch controller> on arswitch0 mdio2: <MDIO> on arswitch0 mdioproxy2: <MII/MDIO proxy, MDIO side> on mdio2 apb0 at irq 4 on nexus0 uart0: <16550 or compatible> at mem 0x18020003-0x1802001a irq 3 on apb0 uart0: console (115200,n,8,1) uart0: fast interrupt uart0: PPS capture mode: DCD gpio0: <Atheros AR71XX GPIO driver> at mem 0x18040000-0x18040fff irq 2 on apb0 gpio0: [GIANT-LOCKED] gpio0: function_set: 0x0 gpio0: function_clear: 0x0 gpio0: gpio pinmask=0x7de800 gpio0: ar71xx_gpio_attach: GPIO 12: func=25, mode=1 gpio0: ar71xx_gpio_attach: GPIO 17: func=7, mode=1 gpiobus0: <GPIO bus> on gpio0 gpioled0: <GPIO led> at pin 15 on gpiobus0 gpioled1: <GPIO led> at pin 13 on gpiobus0 gpioled2: <GPIO led> at pin 18 on gpiobus0 gpioc0: <GPIO controller> on gpio0 pcm0: <Atheros AR71XX I2S/SPDIF-out Audio Interface> at mem 0x180b0000-0x180b0fff irq 7 on apb0 pcm0: Frequency ar71xx_pcm 48000 pcm0: [GIANT-LOCKED] arge0: <Atheros AR71xx built-in ethernet interface> at mem 0x19000000-0x19000fff irq 2 on nexus0 arge0: Overriding MAC address from environment: '[_MAC_XXXXXXXXXX]' miiproxy0: <MII/MDIO proxy, MII side> on arge0 miiproxy0: attached to target mdio2 arge0: finishing attachment, phymask 0001, proxy set miibus4: <MII bus> on miiproxy0 ukphy4: <Generic IEEE 802.3u media interface> PHY 0 on miibus4 ukphy4: OUI 0x00c82e, model 0x0004, rev. 2 ukphy4: none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto arge0: bpf attached arge0: Ethernet address: [_MAC_XXXXXXXXXX] arge1: <Atheros AR71xx built-in ethernet interface> at mem 0x1a000000-0x1a000fff irq 3 on nexus0 arge1: Overriding MAC address from environment: '[_MAC_XXXXXXXXXX]' arge1: arge_attach: overriding MII mode to 'GMII' mii_attach_proxy: not attaching, no mdio device hint for arge1 arge1: finishing attachment, phymask 0000, proxy null arge1: bpf attached arge1: Ethernet address: [_MAC_XXXXXXXXXX] spi0: <AR71XX SPI> at mem 0x1f000000-0x1f00000f on nexus0 spibus0: <SPI bus> on spi0 mx25l0: <M25Pxx Flash Family> at cs 0 mode 0 on spibus0 mx25l0: device type en25q32, size 4096K in 64 sectors of 64K, erase size 64K mx25l1: <M25Pxx Flash Family> at cs 1 mode 0 on spibus0 mx25l1: device type mx25ll32, size 4096K in 64 sectors of 64K, erase size 64K ar71xx_wdog0: <Atheros AR71XX watchdog timer> on nexus0 Device configuration finished. Timecounters tick every 1.000 msec lo0: bpf attached vlan: initialized, using hash tables with chaining tcp_init: net.inet.tcp.tcbhashsize auto tuned to 512 arswitch0port1: link state changed to DOWN arswitch0port2: link state changed to DOWN arswitch0port3: link state changed to DOWN arswitch0port4: link state changed to DOWN GEOM: new disk flash/spi0 GEOM: new disk flash/spi1 MAP: flash/spi0: 0x40000, data=0x40000 "/dev/map/bootloader" MAP: flash/spi0: 40000x3a0000, data=0x3a0000 "/dev/map/upgrade" MAP: search flash/spi0 for key ".!/bin/sh" from 0x100000, step 0x10000 Trying to mount root from cd9660:/dev/map/rootfs.uzip []... MAP: flash/spi0: 40000x110000, data=0x110000 "/dev/map/kernel" MAP: search flash/spi0 for key ".!/bin/sh" from 0x100000, step 0x10000 MAP: flash/spi0: 150000x290000, data=0x290000 "/dev/map/rootfs" MAP: flash/spi0: 3f0000x10000, data=0x10000 "/dev/map/ART" MAP: flash/spi1: 0x400000, data=0x400000 "/dev/map/local" MAP: No valid partition found at flash/spi1.uzip MAP: No valid partition found at map/rootfs.uzip MAP: No valid partition found at map/local.uzip cd9660: RockRidge Extension Warning: no time-of-day clock registered, system time will not be set accurately start_init: trying /sbin/init arswitch0: arswitch_miipollstat: port 2: port -> UP arswitch0: arswitch_miipollstat: port 3: port -> UP arswitch0port3: link state changed to UP arswitch0port4: link state changed to UP MAP: No valid partition found at md0 random: unblocking device. MAP: No valid partition found at md0 lo0: link state changed to UP /tmp: optimization changed from SPACE to TIME cd9660: RockRidge Extension