NYC*BUG dmesgd

Launched in 2004, dmesgd aims to provide a user-submitted repository of searchable *BSD dmesgs. The dmesg(8) command displays the system message buffer's content, and during boot a copy is saved to /var/run/dmesg.boot. This buffer contains the operating system release, name and version, a list of devices identified, plus a whole host of other useful information. We hope others find this resource useful and further contribute to its growth. Contact us at [ admin at lists dot nycbug dot org ]. Note that this site is not a substitute for sending the dmesg directly to the respective project.

---

Date: 2023-04-19 00:56:49
From: yamori813
Description: IOData_WN-G300R3 atu dump support

---<<BOOT>>---
Copyright (c) 1992-2021 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 12.4-STABLE zrouter_yamori813-n234803-50597bd76a22 IOData_WN-G300R3 mips
gcc version 4.2.1 20070831 patched [FreeBSD]
Preloaded elf kernel "kernel" at 0x803980b0.
CPU: MIPS Technologies (MT7620  ) processor v80.150
  MMU: Standard TLB, 32 entries (4K 16K 64K 256K 1M 16M 64M 256M pg sizes)
  L1 i-cache: 4 ways of 512 sets, 32 bytes per line
  L1 d-cache: 4 ways of 256 sets, 32 bytes per line
  L2 cache: disabled
  Config1=0xbee3519e<PerfCount,WatchRegs,MIPS16,EJTAG>
  Config2=0x80000000
  Config3=0x2420<ULRI,DSPP,VInt>
  Config7=0x80010400<WII,AR>
real memory  = 33554432 (32768K bytes)
Physical memory chunk(s):
0x00430000 - 0x01f7ffff, 28639232 bytes (6992 pages)
avail memory = 28024832 (26MB)
random: no preloaded entropy cache
arc4random: WARNING: initial seeding bypassed the cryptographic random device because it was not yet seeded and the knob 'bypass_before_seeding' was enabled.
hostuuid: using 00000000-0000-0000-0000-000000000000
ULE: setup cpu 0
random: entropy device external interface
WARNING: Device "g_ctl" is Giant locked and may be deleted before FreeBSD 14.0.
openfirm: <Open Firmware control device>
WARNING: Device "openfirm" is Giant locked and may be deleted before FreeBSD 14.0.
mem: <memory>
null: <full device, null device, zero device>
nexus0: <MIPS32 root nexus>
ofwbus0: <Open Firmware Device Tree> on nexus0
palmbus0: <MTK Palmbus> mem 0x10000000-0x101fffff on ofwbus0
cpupic0: <MIPS32 Interrupt Controller> on ofwbus0
sysc0: <MTK System Controller> mem 0-0xff on palmbus0
pinctrl0: <MTK Pin Controller> on ofwbus0
pinctrl0: GPIO mode start: 0x001a311c
Processing 1 pin-config node(s) in pinctrl-0 for spi@b00
Processing 1 pin-config node(s) in pinctrl-0 for uartlite@c00
Processing 1 pin-config node(s) in pinctrl-0 for pinctrl
pinctrl0: GPIO mode end  : 0x005ab11d
rstctrl0: <MTK Reset Controller> on ofwbus0
clkctrl0: <MTK Clock Controller> on ofwbus0
intc0: <MTK Interrupt Controller (v2)> mem 0x200-0x2ff irq 7 on palmbus0
gpio0: <MTK GPIO Controller (v1)> mem 0x600-0x633 irq 9 on palmbus0
gpiobus0: <OFW GPIO bus> on gpio0
gpio1: <MTK GPIO Controller (v1)> mem 0x660-0x683 irq 11 on palmbus0
gpiobus1: <OFW GPIO bus> on gpio1
cpulist0: <Open Firmware CPU Group> on ofwbus0
palmbus0: <timer@100> mem 0x100-0x11f irq 5 compat ralink,mt7620a-timer (no driver attached)
palmbus0: <watchdog@120> mem 0x120-0x12f irq 6 compat ralink,mt7620a-wdt (no driver attached)
palmbus0: <memc@300> mem 0x300-0x3ff irq 8 compat ralink,mt7620a-memc (no driver attached)
gpioc0: <GPIO controller> on gpio0
palmbus0: <gpio@638> mem 0x638-0x65b irq 10 disabled compat ralink,mt7620a-gpio (no driver attached)
gpioc1: <GPIO controller> on gpio1
palmbus0: <gpio@688> mem 0x688-0x6ab irq 12 disabled compat ralink,mt7620a-gpio (no driver attached)
spi0: <MTK SPI Controller (v1)> mem 0xb00-0xb3f on palmbus0
spibus0: <OFW SPI bus> on spi0
mx25l0: <M25Pxx Flash Family> at cs 0 mode 0 on spibus0
mx25l0: device type en25qh32, size 4096K in 64 sectors of 64K, erase size 64K
palmbus0: <spi@b40> mem 0xb40-0xb9f disabled compat ralink,rt2880-spi (no driver attached)
uart0: <MTK UART Controller> mem 0xc00-0xcff irq 13 on palmbus0
uart0: console (119047,n,8,1)
uart0: fast interrupt
uart0: PPS capture mode: DCD
palmbus0: <systick@d00> mem 0xd00-0xd0f irq 14 compat ralink,mt7620a-systick (no driver attached)
usbphy0: <MTK USB PHY> on ofwbus0
rt0: <Ralink MT7620 onChip Ethernet driver> mem 0x10100000-0x1010ffff irq 0 on ofwbus0
rt0: MT7620 Ethernet MAC (rev 0x00000000)
rt0: use hardcoded [_MAC_XXXXXXXXXX] macaddr
rt0: bpf attached
rt0: Ethernet address: [_MAC_XXXXXXXXXX]
mtkswitch0: <MTK Switch Driver> mem 0x10110000-0x10117fff irq 1 on ofwbus0
miibus0: <MII bus> on mtkswitch0
ukphy0: <Generic IEEE 802.3u media interface> PHY 0 on miibus0
ukphy0: OUI 0x0017a5, model 0x0000, rev. 13
ukphy0:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
miibus1: <MII bus> on mtkswitch0
ukphy1: <Generic IEEE 802.3u media interface> PHY 1 on miibus1
ukphy1: OUI 0x0017a5, model 0x0000, rev. 13
ukphy1:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
miibus2: <MII bus> on mtkswitch0
ukphy2: <Generic IEEE 802.3u media interface> PHY 2 on miibus2
ukphy2: OUI 0x0017a5, model 0x0000, rev. 13
ukphy2:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
miibus3: <MII bus> on mtkswitch0
ukphy3: <Generic IEEE 802.3u media interface> PHY 3 on miibus3
ukphy3: OUI 0x0017a5, model 0x0000, rev. 13
ukphy3:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
miibus4: <MII bus> on mtkswitch0
ukphy4: <Generic IEEE 802.3u media interface> PHY 4 on miibus4
ukphy4: OUI 0x0017a5, model 0x0000, rev. 13
ukphy4:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
etherswitch0: <Switch controller> on mtkswitch0
mdio0: <MDIO> on mtkswitch0
ehci0: <MTK USB 2.0 Controller> mem 0x101c0000-0x101c0fff irq 2 on ofwbus0
usbus0: EHCI version 1.0
usbus0 on ehci0
ehci0: usbpf: Attached
ohci0: <MTK USB Controller> mem 0x101c1000-0x101c1fff irq 3 on ofwbus0
usbus1 on ohci0
ohci0: usbpf: Attached
ofwbus0: <wmac@10180000> mem 0x10180000-0x101bffff irq 4 compat ralink,rt7620-wmac (no driver attached)
gpioled0: <GPIO LEDs> on ofwbus0
ofwbus0: <gpio-keys-polled> compat gpio-keys-polled (no driver attached)
clock0: <Generic MIPS32 ticker> on nexus0
Timecounter "MIPS32" frequency 300000000 Hz quality 800
Event timer "MIPS32" frequency 300000000 Hz quality 800
Device configuration finished.
Timecounters tick every 10.000 msec
lo0: bpf attached
vlan: initialized, using hash tables with chaining
tcp_init: net.inet.tcp.tcbhashsize auto tuned to 512
mtkswitch0port0: link state changed to DOWN
mtkswitch0port1: link state changed to DOWN
mtkswitch0port2: link state changed to DOWN
mtkswitch0port3: link state changed to DOWN
mtkswitch0port4: link state changed to DOWN
GEOM: new disk flash/spi0
usbus0: 480Mbps High Speed USB v2.0
usbus1: 12Mbps Full Speed USB v1.0
Trying to mount root from cd9660:/dev/flash/spi0s.rootfs.uzip []...
flasugen1.1: <MediaTek OHCI root HUB> at usbus1
uhub0: <MediaTek OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus1
ugen0.1: <MediaTek EHCI root HUB> at usbus0
uhub1: <MediaTek EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> on usbus0
h/spi0: slice 00000000-0002ffff: u-boot (191KB)
flash/spi0: slice 00030000-0003ffff: u-boot-env (63KB)
flash/spi0: slice 00040000-0004ffff: factory (63KB)
flash/spi0: slice 00050000-0015ffff: kernel (1087KB)
flash/spi0: slice 00160000-003fffff: rootfs (2687KB)
flash/spi0: slice 00050000-003fffff: upgrade (3775KB)
MAP: No valid partition found at flash/spi0
MAP: No valid partition found at flash/spi0s.u-boot
MAP: No valid partition found at flash/spi0s.u-boot-env
MAP: No valid partition found at flash/spi0s.factory
MAP: No valid partition found at flash/spi0s.kernel
MAP: No valid partition found at flash/spi0s.rootfs
MAP: No valid partition found at flash/spi0s.upgrade
MAP: No valid partition found at flash/spi0s.rootfs.uzip
cd9660: RockRidge Extension
Warning: no time-of-day clock registered, system time will not be set accurately
Dual Console: Serial Primary, Video Secondary
start_init: trying /sbin/init
uhub0: 1 port with 1 removable, self powered
uhub1: 1 port with 1 removable, self powered
mtkswitch0port0: link state changed to UP
mtkswitch0port1: link state changed to UP
mtkswitch0port2: link state changed to UP
mtkswitch0port3: link state changed to UP
mtkswitch0port4: link state changed to UP
MAP: No valid partition found at md0
random: randomdev_wait_until_seeded unblock wait
random: unblocking device.
MAP: No valid partition found at md0
lo0: link state changed to UP
/tmp: optimization changed from SPACE to TIME

All comments/news/posts are the property of their individual owner and is presented without warranty of suitability, and solely as an informational resource.
This site Copyright © 2004-2024 NYC*BUG.