Launched in 2004, dmesgd aims to provide a user-submitted repository of searchable *BSD dmesgs. The dmesg(8) command displays the system message buffer's content, and during boot a copy is saved to /var/run/dmesg.boot. This buffer contains the operating system release, name and version, a list of devices identified, plus a whole host of other useful information. We hope others find this resource useful and further contribute to its growth. Contact us at [ admin at lists dot nycbug dot org ].


Date: 2023-10-14 07:52:50
From: yamori813
Description: Nec_WG300HP
---<<BOOT>>---
ar934x_chip_init_gmac: gmac_cfg=0x00000041
ar934x_configure_gmac: ETH_CFG=0x00000001
KDB: debugger backends: ddb
KDB: current backend: ddb
Copyright (c) 1992-2021 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 12.4-STABLE zrouter_yamori813-n234820-1641731c46e3 Nec_WG300HP mips
gcc version 4.2.1 20070831 patched [FreeBSD]
VT: init without driver.
Preloaded elf kernel "kernel" at 0x805c49c0.
CPU: MIPS Technologies (Atheros AR9342 rev 3) processor v76.151
  MMU: Standard TLB, 32 entries (4K 16K 64K 256K 1M 16M 64M 256M pg sizes)
  L1 i-cache: 4 ways of 512 sets, 32 bytes per line
  L1 d-cache: 4 ways of 256 sets, 32 bytes per line
  L2 cache: disabled
  Config1=0xbee3519e<PerfCount,WatchRegs,MIPS16,EJTAG>
  Config2=0x80001000
  Config3=0x2c20<ULRI,DSP2P,DSPP,VInt>
  Config7=0x80000800<WII>
real memory  = 67108864 (65536K bytes)
Physical memory chunk(s):
0x00657000 - 0x03efbfff, 59396096 bytes (14501 pages)
avail memory = 58556416 (55MB)
random: no preloaded entropy cache
arc4random: WARNING: initial seeding bypassed the cryptographic random device because it was not yet seeded and the knob 'bypass_before_seeding' was enabled.
hostuuid: using 00000000-0000-0000-0000-000000000000
random: entropy device external interface
snd_unit_init() u=0x00ff8000 [512] d=0x00007c00 [32] c=0x000003ff [1024]
feeder_register: snd_unit=-1 snd_maxautovchans=16 latency=2 feeder_rate_min=1 feeder_rate_max=2016000 feeder_rate_round=25
WARNING: Device "g_ctl" is Giant locked and may be deleted before FreeBSD 14.0.
null: <full device, null device, zero device>
mem: <memory>
nexus0: <MIPS32 root nexus>
argemdio0: <Atheros AR71xx built-in ethernet interface, MDIO controller> at mem 0x19000000-0x19000fff on nexus0
mdio0: <MDIO> on argemdio0
mdioproxy0: <MII/MDIO proxy, MDIO side> on mdio0
arswitch0: <Atheros QCA8337 Ethernet Switch (ver 1 rev 2)> on mdio0
arswitch0: ar8327_fetch_pdata_pad: pad 0: mode=6, rxclk_sel=0, txclk_sel=0, txclk_delay_sel=1, rxclk_delay_sel=2, txclk_delay_en=1, rxclk_enable_en=1, sgmii_delay_en=0, pipe_rxclk_sel=0
arswitch0: ar8327_phy_fixup: called; phy=0; chiprev=2
arswitch0: ar8327_phy_fixup: called; phy=1; chiprev=2
arswitch0: ar8327_phy_fixup: called; phy=2; chiprev=2
arswitch0: ar8327_phy_fixup: called; phy=3; chiprev=2
arswitch0: ar8327_phy_fixup: called; phy=4; chiprev=2
arswitch0: ar8327_atu_learn_default: TODO!
miibus0: <MII bus> on arswitch0
ukphy0: <Generic IEEE 802.3u media interface> PHY 0 on miibus0
ukphy0: OUI 0x00c82e, model 0x0003, rev. 6
ukphy0:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto
miibus1: <MII bus> on arswitch0
ukphy1: <Generic IEEE 802.3u media interface> PHY 1 on miibus1
ukphy1: OUI 0x00c82e, model 0x0003, rev. 6
ukphy1:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto
miibus2: <MII bus> on arswitch0
ukphy2: <Generic IEEE 802.3u media interface> PHY 2 on miibus2
ukphy2: OUI 0x00c82e, model 0x0003, rev. 6
ukphy2:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto
miibus3: <MII bus> on arswitch0
ukphy3: <Generic IEEE 802.3u media interface> PHY 3 on miibus3
ukphy3: OUI 0x00c82e, model 0x0003, rev. 6
ukphy3:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto
miibus4: <MII bus> on arswitch0
ukphy4: <Generic IEEE 802.3u media interface> PHY 4 on miibus4
ukphy4: OUI 0x00c82e, model 0x0003, rev. 6
ukphy4:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto
etherswitch0: <Switch controller> on arswitch0
mdio1: <MDIO> on arswitch0
mdioproxy1: <MII/MDIO proxy, MDIO side> on mdio1
clock0: <Generic MIPS32 ticker> on nexus0
Timecounter "MIPS32" frequency 280000000 Hz quality 800
Event timer "MIPS32" frequency 280000000 Hz quality 800
apb0 at irq 4 on nexus0
uart0: <16550 or compatible> at mem 0x18020003-0x1802001a irq 3 on apb0
uart0: console (115200,n,8,1)
uart0: fast interrupt
uart0: PPS capture mode: DCD
gpio0: <Atheros AR71XX GPIO driver> at mem 0x18040000-0x18040fff irq 2 on apb0
gpio0: [GIANT-LOCKED]
gpio0: function_set: 0x0
gpio0: function_clear: 0x0
gpio0: gpio pinmask=0x7ff81f
gpiobus0: <GPIO bus> on gpio0
gpioled1: <GPIO led> at pin 13 on gpiobus0
gpioc0: <GPIO controller> on gpio0
arge0: <Atheros AR71xx built-in ethernet interface> at mem 0x19000000-0x19000fff irq 2 on nexus0
arge0: Overriding MAC address from environment: 'xx:xx:xx:xx:xx:xx'
arge0: arge_fetch_pll_config: pll_1000 = 0x6000000
arge0: arge_attach: overriding MII mode to 'RGMII'
miiproxy0: <MII/MDIO proxy, MII side> on arge0
arge0: can't attach proxy
arge0: finishing attachment, phymask 0000, proxy null 
arge0: bpf attached
arge0: Ethernet address: xx:xx:xx:xx:xx:xx
spi0: <AR71XX SPI> at mem 0x1f000000-0x1f00000f on nexus0
spibus0: <SPI bus> on spi0
mx25l0: <M25Pxx Flash Family> at cs 0 mode 0 on spibus0
mx25l0: device type mx25ll32, size 4096K in 64 sectors of 64K, erase size 64K
ehci0: <AR71XX Integrated USB 2.0 controller> at mem 0x1b000100-0x1bffffff irq 1 on nexus0
usbus0: EHCI version 1.0
usbus0 on ehci0
ehci0: usbpf: Attached
ar71xx_wdog0: <Atheros AR71XX watchdog timer> on nexus0
Device configuration finished.
Timecounters tick every 1.000 msec
lo0: bpf attached
vlan: initialized, using hash tables with chaining
tcp_init: net.inet.tcp.tcbhashsize auto tuned to 1024
arswitch0port1: link state changed to DOWN
arswitch0port2: link state changed to DOWN
arswitch0port3: link state changed to DOWN
arswitch0port4: link state changed to DOWN
arswitch0port5: link state changed to DOWN
GEOM: new disk flash/spi0
usbus0: 480Mbps High Speed USB v2.0
Trying to mount root from cd9660:/dev/map/rootfs.uzip []...
MAP: flash/spi0: 0x20000, data=0x20000 "/dev/map/bootloader"
MAP: flash/spi0: 20000x3c0000, data=0x3c0000 "/dev/map/upgrade"
MAP: search flash/spi0 for key ".!/bin/sh" from 0x100000, step 0x10000
ugen0.1: <Atheros EHCI root HUB> at usbus0
uhub0: <Atheros EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> on usbus0
MAP: flash/spi0: 20000x140000, data=0x140000 "/dev/map/kernel"
MAP: search flash/spi0 for key ".!/bin/sh" from 0x100000, step 0x10000
MAP: flash/spi0: 160000x280000, data=0x280000 "/dev/map/rootfs"
MAP: flash/spi0: 3f0000x10000, data=0x10000 "/dev/map/ART"
MAP: No valid partition found at map/rootfs.uzip
cd9660: RockRidge Extension
Warning: no time-of-day clock registered, system time will not be set accurately
start_init: trying /sbin/init
uhub0: 1 port with 1 removable, self powered
ugen0.2: <vendor 0x0409 product 0x005a> at usbus0
uhub1 on uhub0
uhub1: <vendor 0x0409 product 0x005a, class 9/0, rev 2.00/1.00, addr 2> on usbus0
uhub1: 4 ports with 4 removable, self powered
arswitch0: arswitch_miipollstat: port 4: port -> UP
arswitch0port5: link state changed to UP
MAP: No valid partition found at md0
random: unblocking device.
MAP: No valid partition found at md0
lo0: link state changed to UP
/tmp: optimization changed from SPACE to TIME