Launched in 2004, dmesgd aims to provide a user-submitted repository of searchable *BSD dmesgs. The dmesg(8) command displays the system message buffer's content, and during boot a copy is saved to /var/run/dmesg.boot. This buffer contains the operating system release, name and version, a list of devices identified, plus a whole host of other useful information. We hope others find this resource useful and further contribute to its growth. Contact us at [ admin at lists dot nycbug dot org ]. Note that this site is not a substitute for sending the dmesg directly to the respective project.
Date: 2015-07-24 22:00:14
From: ajcc
Description: NetBSD/macppc 7.0_RC2 on eMac 1GHz ATi (radeonfb disabled)
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015
The NetBSD Foundation, Inc. All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
NetBSD 7.0_RC2 (GENERIC) #7: Fri Jul 24 23:42:56 CEST 2015
adrian@roentgen:/home/adrian/NetBSD/src/201507240640Z/sys/arch/macppc/compile/obj/GENERIC
total memory = 1024 MB
oea_startup: failed to allocate DEAD ZONE: error=12
avail memory = 981 MB
kern.module.path=/stand/macppc/7.0/modules
timecounter: Timecounters tick every 10.000 msec
found openpic PIC at 80040000
OpenPIC Version 1.2: Supports 4 CPUs and 64 interrupt sources.
bootpath: /pci@f2000000/mac-io@17/ata-4@1f000/disk@0:0/net-uni
mainbus0 (root)
cpu0 at mainbus0: 7455 (Revision 3.3), ID 0 (primary)
cpu0: HID0 0x84d0c1bc<EMCP,TBEN,HIGH_BAT_EN,NAP,DPM,ICE,DCE,XBSEN,SGE,BTIC,LRSTK,FOLD,BHT>, powersave: 1
cpu0: 1000.00 MHz, 256KB L2 cache no parity parity enabled
memory0 at mainbus0: len=384
spdmem0 at memory0
spdmem0: SDRAM, no parity or ECC, 512MB, 133MHz (PC-133)
spdmem0: 13 rows, 10 cols, 2 banks, 4 banks/chip, 7.5ns cycle time
spdmem0: tAA-tRCD-tRP-tRAS: 3-20-20-45
spdmem0: voltage LvTTL (not 5V tolerant), refresh time 7.8us (self-refreshing)
spdmem1 at memory0
spdmem1: SDRAM, no parity or ECC, 512MB, 143MHz (PC-133)
spdmem1: 13 rows, 10 cols, 2 banks, 4 banks/chip, 7.0ns cycle time
spdmem1: tAA-tRCD-tRP-tRAS: 3-15-15-37
spdmem1: voltage LvTTL (not 5V tolerant), refresh time 7.8us (self-refreshing)
uni_n0 at mainbus0 address 0xf8000000
hw-clock at uni_n0 not configured
ki2c0 at uni_n0 address 0xf8001000
iic1 at ki2c0: I2C bus
cereal at ki2c0 address 0x1c0 not configured
uninorth0 at mainbus0
pci0 at uninorth0 bus 0
pci0: i/o space, memory space enabled
pchb0 at pci0 dev 11 function 0
pchb0: Apple Computer UniNorth AGP Interface (rev. 0x00)
genfb0 at pci0 dev 16 function 0found EDID property...
: ATI Technologies Radeon 7500 QW (rev. 0x00)
genfb0: framebuffer at 0x9c008000, size 1024x768, depth 8, stride 1024
wsdisplay0 at genfb0 kbdmux 1: console (default, vt100 emulation)
wsmux1: connecting to wsdisplay0
drm at genfb0 not configured
uninorth1 at mainbus0
pci1 at uninorth1 bus 0
pci1: i/o space, memory space enabled
pchb1 at pci1 dev 11 function 0
pchb1: Apple Computer UniNorth Host-PCI Bridge (rev. 0x00)
obio0 at pci1 dev 23 function 0: addr 0x80000000
obio0: enabling KeyLargo internal modem
zsc0 at obio0 irq 22,23
zstty0 at zsc0 channel 0
zstty1 at zsc0 channel 1
snapper0 at obio0 offset 0x10000: irq 30,1,2
pmu0 at obio0 offset 0x16000 irq 47: rev. 12
pmu0: initializing IIC bus
pmu0: initializing RTC
pmu0: power-mgt not configured
ki2c1 at obio0
iic2 at ki2c1: I2C bus
cereal at ki2c1 address 0x1c0 not configured
deq0 at ki2c1 Apple Digital Equalizer, addr 0x6a
wdc0 at obio0 offset 0x1f000 irq 19, level triggered: DMA transfer
atabus0 at wdc0 channel 0
wdc1 at obio0 offset 0x20000 irq 20, level triggered: DMA transfer
atabus1 at wdc1 channel 0
snapper0: codec: TAS3004
audio0 at snapper0: full duplex, playback, capture
ohci0 at pci1 dev 24 function 0: Apple Computer KeyLargo USB Controller (rev. 0x00)
ohci0: interrupting at irq 27
ohci0: OHCI version 1.0
usb0 at ohci0: USB revision 1.0
ohci1 at pci1 dev 25 function 0: Apple Computer KeyLargo USB Controller (rev. 0x00)
ohci1: interrupting at irq 28
ohci1: OHCI version 1.0
usb1 at ohci1: USB revision 1.0
uninorth2 at mainbus0
pci2 at uninorth2 bus 0
pci2: i/o space, memory space enabled
pchb2 at pci2 dev 11 function 0
pchb2: Apple Computer UniNorth Host-PCI Bridge (rev. 0x00)
fwohci0 at pci2 dev 14 function 0: Lucent Technologies FW322/323 IEEE 1394 Host Controller (rev. 0x00)
fwohci0: interrupting at irq 40
fwohci0: OHCI version 1.0 (ROM=0)
fwohci0: No. of Isochronous channels is 8.
fwohci0: EUI64 [_MAC_XXXXXXXXXX]:63:4e
fwohci0: Phy 1394a available S400, 2 ports.
fwohci0: Link S400, max_rec 2048 bytes.
ieee1394if0 at fwohci0: IEEE1394 bus
fwip0 at ieee1394if0: IP over IEEE1394
fwohci0: Initiate bus reset
gem0 at pci2 dev 15 function 0: Apple Computer GMAC Ethernet (rev. 0x01)
gem0: interrupting at irq 41
bmtphy0 at gem0 phy 0: BCM5221 10/100 media interface, rev. 4
bmtphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
gem0: Ethernet address [_MAC_XXXXXXXXXX], 10KB RX fifo, 4KB TX fifo
vmmask 67180000 schedmask 7ff80000 highmask 7ff80000
timecounter: Timecounter "clockinterrupt" frequency 100 Hz quality 0
timecounter: Timecounter "mftb" frequency 33178834 Hz quality 100
fwohci0: BUS reset
fwohci0: node_id=0xc800ffc0, gen=2, CYCLEMASTER mode
ieee1394if0: 1 nodes, maxhop <= 0 cable IRM irm(0) (me)
ieee1394if0: bus manager 0
uhub0 at usb0: Apple Computer OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhub1 at usb1: Apple Computer OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
uhub2 at uhub0 port 1: Mitsumi Electric Hub in Apple Extended USB Keyboard, class 9/0, rev 1.10/3.95, addr 2
uhub2: 3 ports with 2 removable, bus powered
wd0 at atabus0 drive 0
wd0: <ST340015A>
wd0: drive supports 16-sector PIO transfers, LBA addressing
wd0: 38166 MB, 77545 cyl, 16 head, 63 sec, 512 bytes/sect x 78165360 sectors
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 5 (Ultra/100)
wd0(wdc0:0:0): using PIO mode 4, DMA mode 2, Ultra-DMA mode 4 (Ultra/66) (using DMA)
atapibus0 at atabus1: 2 targets
cd0 at atapibus0 drive 0: <_NEC DV-5800A, , 1.0A> cdrom removable
cd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 2 (Ultra/33)
cd0(wdc1:0:0): using PIO mode 4, DMA mode 2 (using DMA)
uhidev0 at uhub2 port 1 configuration 1 interface 0
uhidev0: Logitech Apple Optical USB Mouse, rev 2.00/3.40, addr 3, iclass 3/1
ums0 at uhidev0: 1 button
wsmouse0 at ums0 mux 0
uhidev1 at uhub2 port 3 configuration 1 interface 0
uhidev1: Mitsumi Electric Apple Extended USB Keyboard, rev 1.10/3.95, addr 4, iclass 3/1
ukbd0 at uhidev1
wskbd0 at ukbd0: console keyboard, using wsdisplay0
uhidev2 at uhub2 port 3 configuration 1 interface 1
uhidev2: Mitsumi Electric Apple Extended USB Keyboard, rev 1.10/3.95, addr 4, iclass 3/0
uhidev2: 3 report ids
uhid0 at uhidev2 reportid 2: input=1, output=0, feature=0
uhid1 at uhidev2 reportid 3: input=3, output=0, feature=0
Kernelized RAIDframe activated
swwdog0: software watchdog initialized
boot device: wd0
root on wd0a dumps on wd0b
root file system type: ffs