Launched in 2004, dmesgd aims to provide a user-submitted repository of searchable *BSD dmesgs. The dmesg(8) command displays the system message buffer's content, and during boot a copy is saved to /var/run/dmesg.boot. This buffer contains the operating system release, name and version, a list of devices identified, plus a whole host of other useful information. We hope others find this resource useful and further contribute to its growth. Contact us at [ admin at lists dot nycbug dot org ].
Date: 2012-01-17 17:34:17
From: Bryan Irvine
Description: Lemote Yeeloong 8089-B
OpenBSD 5.0 (GENERIC) #26: Wed Aug 17 10:41:08 MDT 2011 xxx@xxx.xxx:/usr/src/sys/arch/loongson/compile/GENERIC real mem = 1073741824 (1024MB) avail mem = 1059209216 (1010MB) mainbus0 at root: Lemote Yeeloong cpu0 at mainbus0: STC Loongson2F CPU 797 MHz, STC Loongson2F FPU cpu0: cache L1-I 64KB D 64KB 4 way, L2 512KB 4 way bonito0 at mainbus0: memory and PCI-X controller, rev 1 pci0 at bonito0 bus 0 rl0 at pci0 dev 7 function 0 Realtek 8139 rev 0x10: irq 5, address xx:xx:xx:xx:xx:xx rlphy0 at rl0 phy 0: RTL internal PHY smfb0 at pci0 dev 8 function 0 Silicon Motion LynxEM+ rev 0xb0 wsdisplay0 at smfb0 mux 1: console (std, vt100 emulation) ohci0 at pci0 dev 9 function 0 NEC USB rev 0x44: irq 7, version 1.0 ehci0 at pci0 dev 9 function 1 NEC USB rev 0x05: irq 7 usb0 at ehci0: USB revision 2.0 uhub0 at usb0 NEC EHCI root hub rev 2.00/1.00 addr 1 glxpcib0 at pci0 dev 14 function 0 AMD CS5536 ISA rev 0x03: rev 3, 32-bit 3579545Hz timer, watchdog, gpio gpio1 at glxpcib0: 32 pins pciide0 at pci0 dev 14 function 2 AMD CS5536 IDE rev 0x01: DMA, channel 0 wired to compatibility, channel 1 wired to compatibility wd0 at pciide0 channel 0 drive 0: <FUJITSU MHZ2160BH G2> wd0: 16-sector PIO, LBA48, 152627MB, 312581808 sectors wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2 pciide0: channel 1 ignored (disabled) auglx0 at pci0 dev 14 function 3 AMD CS5536 Audio rev 0x01: isa irq 9, CS5536 AC97 ac97: codec id 0x414c4760 (Avance Logic ALC655 rev 0) audio0 at auglx0 ohci1 at pci0 dev 14 function 4 AMD CS5536 USB rev 0x02: isa irq 11, version 1.0, legacy support ehci1 at pci0 dev 14 function 5 AMD CS5536 USB rev 0x02: isa irq 11 usb1 at ehci1: USB revision 2.0 uhub1 at usb1 AMD EHCI root hub rev 2.00/1.00 addr 1 usb2 at ohci0: USB revision 1.0 uhub2 at usb2 NEC OHCI root hub rev 1.00/1.00 addr 1 isa0 at glxpcib0 pckbc0 at isa0 port 0x60/5 pckbd0 at pckbc0 (kbd slot) pckbc0: using irq 1 for kbd slot wskbd0 at pckbd0: console keyboard, using wsdisplay0 pms0 at pckbc0 (aux slot) pckbc0: using irq 12 for aux slot wsmouse0 at pms0 mux 0 mcclock0 at isa0 port 0x70/2: mc146818 or compatible ykbec0 at isa0 port 0x381/3 usb3 at ohci1: USB revision 1.0 uhub3 at usb3 AMD OHCI root hub rev 1.00/1.00 addr 1 clock0 at mainbus0: ticker on int5 using count register apm0 at mainbus0 umass0 at uhub1 port 1 configuration 1 interface 0 Generic USB2.0-CRW rev 2.00/58.87 addr 2 umass0: using SCSI over Bulk-Only scsibus0 at umass0: 2 targets, initiator 0 sd0 at scsibus0 targ 1 lun 0: <Generic-, Multi-Card, 1.00> SCSI0 0/direct removable serial.0bda0158114173400000 urtw0 at uhub1 port 4 Realtek RTL8187B rev 2.00/2.00 addr 3 urtw0: RTL8187B rev E, address xx:xx:xx:xx:xx:xx vscsi0 at root scsibus1 at vscsi0: 256 targets softraid0 at root scsibus2 at softraid0: 256 targets pmon bootpath: /dev/disk/wd0 boot device: wd0 root on wd0a swap on wd0b dump on wd0b WARNING: / was not properly unmounted ehci_idone: ex=0xc000000000088200 is done! ehci_idone: ex=0xc000000000088200 is done! apm0: battery high urtw1 at uhub1 port 2 Realtek RTL8187 rev 2.00/1.00 addr 4 urtw1: RTL8187 rev 0x04, RFv2, address xx:xx:xx:xx:xx:xx