Launched in 2004, dmesgd aims to provide a user-submitted repository of searchable *BSD dmesgs. The dmesg(8) command displays the system message buffer's content, and during boot a copy is saved to /var/run/dmesg.boot. This buffer contains the operating system release, name and version, a list of devices identified, plus a whole host of other useful information. We hope others find this resource useful and further contribute to its growth. Contact us at [ admin at lists dot nycbug dot org ]. Note that this site is not a substitute for sending the dmesg directly to the respective project.
Date: 2015-03-12 16:43:08
From: AaronB
Description: Sun SparcStation 20, dual 150mhz Hypersparc, Netboot
initialized boothowt from bootloader: 0
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
2006, 2007, 2008, 2009, 2010, 2011, 2012
The NetBSD Foundation, Inc. All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
NetBSD 6.1.5 (GENERIC.MP)
total memory = 127 MB
avail memory = 119 MB
timecounter: Timecounters tick every 10.000 msec
bootpath: /iommu@f,e0000000/sbus@f,e0001000/qec@3,20000/be@0,0
mainbus0 (root): SUNW,SPARCstation-20: [_HOSTID_XXXXX]
cpu0 at mainbus0: mid 8: RT620/625 @ 150 MHz, on-chip FPU
cpu0: 512K byte write-back, 32 bytes/line, sw flush: cache enabled
cpu1 at mainbus0: mid 10: RT620/625 @ 150 MHz, on-chip FPU
cpu1: 512K byte write-back, 32 bytes/line, sw flush: cache enabled
obio0 at mainbus0
clock0 at obio0 slot 0 offset 0x200000: mk48t08
timer0 at obio0 slot 0 offset 0x300000: delay constant 48, frequency = 1000000 Hz
timecounter: Timecounter "timer-counter" frequency 1000000 Hz quality 100
zs0 at obio0 slot 0 offset 0x100000 level 12 softpri 6
zstty0 at zs0 channel 0 (console i/o)
zstty1 at zs0 channel 1
zs1 at obio0 slot 0 offset 0x0 level 12 softpri 6
zstty4 at zs1 channel 0
kbd0 at zstty4
zstty5 at zs1 channel 1
ms0 at zstty5
wsmouse0 at ms0 mux 0
fdc0 at obio0 slot 0 offset 0x700000 level 11: no drives attached
auxreg0 at obio0 slot 0 offset 0x800000
power0 at obio0 slot 0 offset 0xa01000 level 2
iommu0 at mainbus0 ioaddr 0xe0000000: version 0x3/0x1, page-size 4096, range 64MB
sbus0 at iommu0: clock = 25 MHz
dma0 at sbus0 slot 15 offset 0x400000: DMA rev 2
esp0 at dma0 slot 15 offset 0x800000 level 4: ESP200, 40MHz, SCSI ID 7
scsibus0 at esp0: 8 targets, 8 luns per target
ledma0 at sbus0 slot 15 offset 0x400010: DMA rev 2
le0 at ledma0 slot 15 offset 0xc00000 level 6: address [_MAC_XXXXXXXXXX]
le0: 8 receive buffers, 2 transmit buffers
bpp0 at sbus0 slot 15 offset 0x4800000 level 2 (ipl 3): DMA rev 2
dbri0 at sbus0 slot 14 offset 0x10000 level 9: rev e
qec0 at sbus0 slot 3 offset 0x20000: 128K memory
be0 at qec0 slot 0 offset 0x0 level 4 (ipl 7): rev 1, address [_MAC_XXXXXXXXXX]
on-board transceiver at be0: 10baseT, 100baseTX, auto
eccmemctl0 at mainbus0 ioaddr 0x0: version 0x0/0x2
timecounter: Timecounter "clockinterrupt" frequency 100 Hz quality 0
cpu0: booting secondary processors: cpu1
wskbd0 at kbd0 mux 1
scsibus0: waiting 2 seconds for devices to settle...
kbd0: reset failed
Kernelized RAIDframe activated
dbri0: speakerbox detected
dbri0: cs4215 rev E found at offset 8
audio0 at dbri0: full duplex, playback, capture, mmap
can't determine root device
root device (default qec0):
dump device:
file system (default generic):
can't determine root device
root device (default qec0): be0
dump device:
file system (default generic): nfs
root on be0
nfs_boot: trying DHCP/BOOTP
be0: link up at 100 Mbps
nfs_boot: DHCP next-server:[_IP_XXXXXXXXX]
nfs_boot: my_name=transmit
nfs_boot: my_addr=192.168.102.2
nfs_boot: my_mask=255.255.255.0
nfs_boot: gateway=192.168.102.1
root on endure:/netfs/transmit
warning: no /dev/console
init path (default /sbin/init):