Launched in 2004, dmesgd aims to provide a user-submitted repository of searchable *BSD dmesgs. The dmesg(8) command displays the system message buffer's content, and during boot a copy is saved to /var/run/dmesg.boot. This buffer contains the operating system release, name and version, a list of devices identified, plus a whole host of other useful information. We hope others find this resource useful and further contribute to its growth. Contact us at [ admin at lists dot nycbug dot org ]. Note that this site is not a substitute for sending the dmesg directly to the respective project.
Date: 2016-01-24 23:02:55
From: ajcc
Description: NetBSD/sgimips 6.1.5 on Indy (IP24)
pmap_steal_memory: seg 0: 0x8002 0x8002 0x800f 0x800f
pmap_steal_memory: seg 0: too small for 41 pages
pmap_steal_memory: seg 1: 0x800f 0x800f 0x8068 0x8068
pmap_steal_memory: seg 0: 0x8002 0x8002 0x800f 0x800f
pmap_steal_memory: seg 0: 0x8004 0x8004 0x800f 0x800f
pmap_steal_memory: seg 0: too small for 603 pages
pmap_steal_memory: seg 1: 0x8038 0x8038 0x8068 0x8068
pmap_steal_memory: seg 1: too small for 603 pages
pmap_steal_memory: seg 2: 0x84b3 0x84b3 0x8740 0x8740
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
2006, 2007, 2008, 2009, 2010, 2011, 2012
The NetBSD Foundation, Inc. All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
NetBSD 6.1.5 (GENERIC32_IP2x)
total memory = 128 MB
(768 KB reserved for ARCS)
avail memory = 120 MB
timecounter: Timecounters tick every 10.000 msec
mainbus0 (root): SGI-IP22 [SGI, 6909d64c], 1 processor
cpu0 at mainbus0: MIPS R4400 CPU (0x460) Rev. 6.0 with MIPS R4010 FPC Rev. 0.0
cpu0: 48 TLB entries, 16MB max page size
cpu0: 16KB/16B direct-mapped L1 instruction cache
cpu0: 16KB/16B direct-mapped write-back L1 data cache
cpu0: 1024KB/128B direct-mapped write-back L2 unified cache
int0 at mainbus0 addr 0x1fbd9880
int0: bus 100MHz, CPU 200MHz
imc0 at mainbus0 addr 0x1fa00000: revision 3
gio0 at imc0
newport0 at gio0: SGI NG1 (board revision 7, cmap revision 5, xmap revision 5, vc2 revision 0), depth 8
wsdisplay0 at newport0 kbdmux 1
wsmux1: connecting to wsdisplay0
hpc0 at gio0: SGI HPC3 (onboard)
zsc0 at hpc0 offset 0x59830
zstty0 at zsc0 channel 1 (console i/o)
zstty1 at zsc0 channel 0
pckbc0 at hpc0 offset 0x59840
sq0 at hpc0 offset 0x54000: SGI Seeq 80c03
sq0: Ethernet address [_MAC_XXXXXXXXXX]
wdsc0 at hpc0 offset 0x44000: WD33C93B (20.0 MHz clock, BURST DMA, SCSI ID 0)
wdsc0: microcode revision 0x0d, Fast SCSI
scsibus0 at wdsc0: 8 targets, 8 luns per target
haltwo0 at hpc0 offset 0x58000: HAL2 revision 4.1.0
audio0 at haltwo0: half duplex, playback, capture
pi1ppc0 at hpc0 offset 0x59800
pi1ppc0: capabilities=0x8<PS2>
ppbus0 at pi1ppc0
ppbus0: No IEEE1284 device found.
lpt0 at ppbus0: port mode = 0x1<COMPATIBLE>
panel0 at hpc0 offset 0x59850
dsclock0 at mainbus0 addr 0x1fbe0000
ioc0 at mainbus0 addr 0x1fbd9800: rev 0, machine Indy (Guinness), board rev 0
timecounter: Timecounter "clockinterrupt" frequency 100 Hz quality 0
timecounter: Timecounter "mips3_cp0_counter" frequency 100000000 Hz quality 100
scsibus0: waiting 2 seconds for devices to settle...
sd0 at scsibus0 target 1 lun 0: <SEAGATE, ST34520N, 1206> disk fixed
sd0: 4340 MB, 9006 cyl, 4 head, 246 sec, 512 bytes/sect x 8888924 sectors
sd0: sync (100.00ns offset 12), 8-bit (10.000MB/s) transfers, tagged queueing
sd1 at scsibus0 target 2 lun 0: <QUANTUM, FIREBALL_TM1080S, 3000> disk fixed
sd1(wdsc0:0:2:0): Check Condition on CDB: 0x00 00 00 00 00 00
SENSE KEY: Not Ready
ASC/ASCQ: Logical Unit Not Ready, Cause Not Reportable
sd1: drive offline
sd1: sync (100.00ns offset 12), 8-bit (10.000MB/s) transfers, tagged queueing
boot device: sd0
root on sd0a dumps on sd0b
root file system type: ffs