Launched in 2004, dmesgd aims to provide a user-submitted repository of searchable *BSD dmesgs. The dmesg(8) command displays the system message buffer's content, and during boot a copy is saved to /var/run/dmesg.boot. This buffer contains the operating system release, name and version, a list of devices identified, plus a whole host of other useful information. We hope others find this resource useful and further contribute to its growth. Contact us at [ admin at lists dot nycbug dot org ].
Date: 2021-01-01 15:10:55
From: r
Description: OpenBSD 6.8 i386 on PC Engines alix2d13, 256MB RAM, 1 CPU core
OpenBSD 6.8 (GENERIC) #2: Sat Dec 5 04:45:18 MST 2020 xxx@xxx.xxx:/usr/src/sys/arch/i386/compile/GENERIC real mem = 267931648 (255MB) avail mem = 246730752 (235MB) random: good seed from bootblocks mpath0 at root scsibus0 at mpath0: 256 targets mainbus0 at root bios0 at mainbus0: date 11/05/08, BIOS32 rev. 0 @ 0xfd088 pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000 pcibios0: pcibios_get_intr_routing - function not supported pcibios0: PCI IRQ Routing information unavailable. pcibios0: PCI bus #0 is the last bus bios0: ROM list: 0xe0000/0xa800 cpu0 at mainbus0: (uniprocessor) cpu0: Geode(TM) Integrated Processor by AMD PCS ("AuthenticAMD" 586-class) 499 MHz, 05-0a-02 cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX,MMXX,3DNOW2,3DNOW mtrr: K6-family MTRR support (2 registers) pci0 at mainbus0 bus 0: configuration mode 1 (no bios) pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x33 glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES vr0 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 10, address xx:xx:xx:xx:xx:xx ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034 vr1 at pci0 dev 10 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 11, address xx:xx:xx:xx:xx:xx ukphy1 at vr1 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034 vr2 at pci0 dev 11 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 15, address xx:xx:xx:xx:xx:xx ukphy2 at vr2 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034 glxpcib0 at pci0 dev 15 function 0 "AMD CS5536 ISA" rev 0x03: rev 3, 32-bit 3579545Hz timer, watchdog, gpio, i2c gpio0 at glxpcib0: 32 pins iic0 at glxpcib0 maxtmp0 at iic0 addr 0x4c: lm86 pciide0 at pci0 dev 15 function 2 "AMD CS5536 IDE" rev 0x01: DMA, channel 0 wired to compatibility, channel 1 wire d to compatibility wd0 at pciide0 channel 0 drive 0: <WDC WD3200BEVE-00A0HT0> wd0: 16-sector PIO, LBA48, 305245MB, 625142448 sectors wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 4 pciide0: channel 1 ignored (disabled) ohci0 at pci0 dev 15 function 4 "AMD CS5536 USB" rev 0x02: irq 12, version 1.0, legacy support ehci0 at pci0 dev 15 function 5 "AMD CS5536 USB" rev 0x02: irq 12 usb0 at ehci0: USB revision 2.0 uhub0 at usb0 configuration 1 interface 0 "AMD EHCI root hub" rev 2.00/1.00 addr 1 isa0 at glxpcib0 isadma0 at isa0 com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo com0: console com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo pcppi0 at isa0 port 0x61 spkr0 at pcppi0 npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16 usb1 at ohci0: USB revision 1.0 uhub1 at usb1 configuration 1 interface 0 "AMD OHCI root hub" rev 1.00/1.00 addr 1 nvram: invalid checksum uftdi0 at uhub1 port 2 configuration 1 interface 0 "FTDI TTL232R-3V3" rev 2.00/6.00 addr 2 ucom0 at uftdi0 portno 1 vscsi0 at root scsibus1 at vscsi0: 256 targets softraid0 at root scsibus2 at softraid0: 256 targets root on wd0a (xxxxxxxxxxxxxxxx.a) swap on wd0b dump on wd0b clock: unknown CMOS layout pppoe0: LCP keepalive timeout pppoe0: LCP keepalive timeout pppoe0: LCP keepalive timeout pppoe0: LCP keepalive timeout pppoe0: LCP keepalive timeout hw.sensors.maxtmp0.temp0=37.00 degC (Internal) hw.sensors.maxtmp0.temp1=43.62 degC (External) hw.sensors.nmea0.indicator0=On (Signal), OK hw.sensors.nmea0.timedelta0=-0.000440 secs (GPS autonomous), OK, Fri Jan 1 14:48:03.999 hw.sensors.nmea0.angle0=xx.xxxx degrees (Latitude), OK hw.sensors.nmea0.angle1=xx.xxxx degrees (Longitude), OK hw.sensors.nmea0.distance0=135.300 m (Altitude), OK hw.sensors.nmea0.velocity0=0.175 m/s (Ground speed), OK